Quantum Scalar i6000 User Manual page 177

Quantum Scalar i6000 User's Guide
2 Use the following table to assist you in completing the elements on
the IPv4 Network Configuration dialog box.
Element Description
In the Host Settings area:
DHCP If Dynamic Host Configuration Protocol (DHCP) is
enabled on your network, do one of the following:
• Select Enable to have DHCP automatically
• Select Disable to make the IP Address, Subnet
Library Name The network name that you want to assign to the
library.
IP Address The IP address of the library. This text box is
available only if DHCP is disabled.
Subnet Mask The subnet mask. This text box is available only if
DHCP is disabled.
Default The IP address of the default gateway for your
Gateway portion of the Ethernet network. This text box is
available only if DHCP is disabled.
In the Port Settings area:
Auto Negotiate • Select Enable to have the library automatically
• Select Disable to make the Speed options
The port speed (10 Mbps or 100 Mbps). Speed
Speed
options are available only if Auto Negotiate is
disabled.
The current port settings are listed in the Current Port Settings
section. For more information, see
Chapter 3: Configuring Your Library
Setting Up the Network Configuration
configure the library network settings. Enable
makes the IP Address, Subnet Mask, and
Default Gateway text boxes unavailable.
Mask, and Default Gateway text boxes
available for you to manually set the library
network settings.
negotiate port speeds. Enable makes the Speed
options unavailable.
available for you to manually set the port speed.
Viewing the Current Network
163