Downloading Drive Firmware For Autoleveling - Quantum Scalar i6000 User Manual

Chapter 3: Configuring Your Library
Working With Partitions
152
drive firmware version, and then click the version in the
Firmware Version drop-down list.
Note: Only drives that are attached to an FC I/O blade or an
Ethernet Expansion blade can participate in drive
firmware autoleveling operations.
19 To continue, click Next.
The Partitions - Summary Information dialog box appears.
20 Verify that the parameters you set are correct.
21 If the summary information is correct, click Modify.
Note: After you click Modify, the Cancel button becomes
unavailable.
The Partitions - Completed dialog box appears.
22 Review the information to make sure it is correct.
23 If you want to view the drive information after modifying the
partition, click Next.
24 Click Finish.
The Partitions dialog box appears again.
25 Click Close.

Downloading Drive Firmware for Autoleveling

Note: Before you begin the following procedure, make sure that you
have obtained the new drive firmware image from Quantum
technical support and placed it in an accessible location on
your laptop.
1 On the Partitions - Step 6: Configure Drive Firmware
Autoleveling dialog box, click Manage Images.
The Manage Drive Firmware Images dialog box appears.
Quantum Scalar i6000 User's Guide