Setting Aisle Lights - Quantum Scalar i6000 User Manual

Chapter 3: Configuring Your Library

Setting Aisle Lights

Setting Aisle Lights
246
logical serial number, firmware version, drive type, and interface
type:
• SCSI tape drives — SCSI ID
• Fibre Channel (FC) tape drives — World Wide Name (WWN) and
loop ID, speed, and connection type
Note: If the FC tape drive is attached to an FC I/O blade, the
WWN indicates the WWN of the I/O blade, not the tape
drive.
• I/O blade information — Blade type, location, firmware version,
serial number, WWN, and CC LUN
Before you can e-mail the configuration record, the library e-mail
account must be configured. For information on configuring the library
e-mail account, see Configuring E-mail
For instructions on how to e-mail or save the configuration record, see
Mailing or Saving the Configuration Record
Aisle lights are optional on each module, and are mounted to the roof
of each module to illuminate the inside of the library.
To set the duration for aisle lighting:
1 From the main console, select Setup > System Settings > Aisle
Lights.
The Aisle Light Settings dialog box appears.
2 Select a duration for the light to illuminate: 30 minutes, 1 hour, or
Always Off.
3 Click OK.
Note: Regardless of the selected setting, the aisle lights will turn off
automatically during all inventory and teach operations. At the
completion of these events the lights are automatically turned
back on if they were on prior to these operations.
on page 183.
on page 525.
Quantum Scalar i6000 User's Guide