Table 24 Test Results - Quantum scalar i2000 User Manual

Table 24 Test Results

Test Results
PASSED
MARGINAL
FAILED
INCOMPLETE
SKIPPED
WARNING
STOPPED
Scalar i2000 User's Guide
Test Results
The results of all subtests are displayed on the Verification Tests dialog
box after each individual test is completed. See
of test results.
Explanation
Completed the test without reported errors.
Completed the test, but the system had to retry or had to skip part of the test. A
MARGINAL result is considered PASSED, but the log should be checked to see if
the marginality can be corrected.
An error has been found and needs to be corrected. A fatal error, or an error that
causes a part of the system to become disabled, will halt the test.
This portion of a test was incomplete due to an interruption or a portion of the test
was run (for example, no scratch tape was used so must only use existing tapes).
An incomplete will occur when the door is opened, an abort command is issued,
or when the Robotics Enable button is pressed.
This portion of the test was skipped. The cause is that either a scratch tape was not
present or the library was not configured for the test.
A warning is additional information about the test that the user should know. For
example, if a calibration failed, but the stored offsets are analyzed, a warning
should be posted that states that the offset check might not be accurate.
The test was interrupted. The log will show the result to provide a record of test
interruption.
Note
A single problem in the library can cause failed
results in multiple tests. After taking action to
correct a failed result, run tests that yielded
marginal or failed results again.
Chapter 5 Maintaining Your Library
Maintenance Actions
table 24 for an explanation
5
283