Configuring Host Access To Storage Networking Drives And Partitions - Quantum Scalar i6000 User Manual

Quantum Scalar i6000 User's Guide

Configuring Host Access to Storage Networking Drives and Partitions

13 Click Next to display the Select the partitions for host access
dialog box. In order for a partition to appear on the list, both the
following conditions must apply:
• the partition has its control path configured via control path
bridging (meaning, the control path is via an HP LTO-5 or LTO-6
drive connected to an Ethernet Expansion blade); and
• the control path drive has an SNW license applied to it.
14 To add partitions to the host access group, select their check boxes
in the Select column.
15 For each partition selected, make sure to select either Port 1 or Port
2 for processing host medium changer commands (the default is
Port 1). Both drive ports are active and have different WWPNs, so
the port you choose must be physically connected to a host or
switch or the host will not see it. The port you choose depends on
which ports on the control path drive are physically cabled.
16 Click Finish to create the new access group.
Click OK in the The Host Access was updated successfully dialog box.
Chapter 10: Storage Networking
381