Setting Up The Network Configuration - Quantum Scalar i6000 User Manual

Setting Up the Network Configuration

Quantum Scalar i6000 User's Guide
Make sure that your library is attached to the network before you use
the Network Configuration command.
Caution: You must fully understand all network issues before you
change the network configuration for an already
configured library. It is recommended that you consult with
your network administrator before changing your network
configuration.
Note: To set up an iPv6 network connection, make sure that the IPv6
option is enabled on the Physical Library dialog, as described
in Setting Up Policies for the Physical Library
Note: For all site-to-site customer firewall network settings, see
Appendix B, Network Port
1 Log on as an administrator.
2 If you are not already working from the physical library, select the
physical library from the View menu.
3 Do one of the following, depending on whether IPv6 is enabled or
disabled and the protocol of the network connection you want to
configure:
• IPv4 Configuration — Proceed to
Configuration
• IPv6 Configuration — Proceed to
Configuration
Note: The IPv6 Configuration submenu only appears if you
have enabled IPv6 for the physical library, as described
in Setting Up Policies for the Physical Library
page 177.
• DNS Configuration — Proceed to
page 166.
Chapter 3: Configuring Your Library
Setting Up the Network Configuration
Settings.
Setting up IPv4 Network
on page 162.
Setting up IPv6 Network
on page 164.
Configuring DNS
on page 177.
on
on
161