Running Calibration Teach - Quantum Scalar i6000 User Manual

Chapter 15: Maintaining Your Library
Maintenance Actions
574
information about them. Teach results appear in the Results text
box when the process completes. If the configuration teach process
completes successfully, the Teach dialog box could close
automatically.

Running Calibration Teach

Starting the calibration teach process causes the library to assess the
position and alignment of various library components through the use
of calibration targets. Use this process to avoid cartridge-handling
problems caused by rack, drive, or I/E station misalignments.
Rack alignment calibration targets are tabs that are located on two
special magazines in each drive-side and door-side storage rack. I/E
station targets are small square holes that are located at the top and
bottom of the I/E station. Whenever you perform work on the library
that could affect the position of rack, drive, or I/E station calibration
targets, even slightly, you should initiate the calibration teach process.
Note: When a Gen 1 library reaches 20,000 moves after the last
calibration occurred, and if then the library is rebooted or an
access door is closed, the library automatically recalibrates
itself.
1 Log on as an administrator.
2 Make sure that you are viewing the physical library. From the View
menu, click the name of the physical library.
3 Click Tools > Teach.
Note: f the physical library is not offline, you receive a message
that asks you whether you want to take it offline. Click Yes.
The Teach dialog box appears with Configure selected by default.
Quantum Scalar i6000 User's Guide