Sub-Test Descriptions - Quantum Scalar i6000 User Manual

Hide thumbs Also See for Scalar i6000:

Table of Contents

Chapter 15: Maintaining Your Library

Maintenance Actions

• Frame test - This test includes the same individual tests as the Install

Test, but enables you to specify a range of modules rather than

testing all modules.

• Configuration test - This test includes the picker assembly and

scanner fiducial tests.

Both tests enable you to select a range of modules and racks to test. For

example, if you have a four-module library, you can select to test only

modules 3 and 4. The Frame test performs the same operations as the

installation verification test, except there are frame and rack range

parameters available.

The FRU test enables you to verify the replacement of a FRU. When the

FRU test is selected, you can select any of the following sub-tests:

• Accessor Assembly

• Picker Assembly

• Drive Sled Assembly

• IE Assembly

• Scan Barcode

When one of the sub-tests is selected, you may be prompted to enter

additional information. For example, the Select FRU dialog box has tabs

along the top to select individual drives, I/E stations, and scratch tapes.

The Custom test enables you to run the Library Alignment sub-test on a

per-rack basis.

Sub-test Descriptions

Use the Verification Tests dialog box to select the test and sub-test, to

start the test, and view results.

Verification Tests dialog box. To display the dialog box, click Tools >

Verification Tests.

shows the parts of the

Quantum Scalar i6000 User's Guide