Table of Contents
Advertisement
Outgoing E
mail Server
-
CLI Commands
Sending a Test E-mail
E
mail Home CLI
-
Commands
Other System Configuration CLI Commands
The following e-mail server CLI commands are supported:
•
Displaying the Outgoing E-mail Server
•
Setting the Outgoing E-mail Server
•
Deleting the Outgoing E-mail Server
Displaying the Outgoing E-mail Server
syscli --get emailserver
This CLI command allows the user to display the outgoing e-mail server. An
example output of the outgoing e-mail server is shown below.
Outgoing E‐mail Server
Host name or IP address = 10.40.164.50
From Email address = DX75@quantum.com
Setting the Outgoing E-mail Server
syscli --set emailserver --hostname <server_name_or_IP> --emailaddr
<from_email_address>
This CLI command allows the admin user to add an outgoing e-mail server that
will be used to send the e-mail to configured recipients.
Deleting the Outgoing E-mail Server
syscli --del emailserver
This CLI command allows the admin user to delete an outgoing e-mail server.
syscli --send testemail --name <recipient_name>
This CLI command allows the admin user to send a test e-mail to verify the
e-mail configuration.
The following e-mail home commands are supported:
•
Getting the E-mail Home Information
•
Enabling or Disabling the E-mail Home Scheduler
•
Adding an E-mail Home Schedule Recipient
•
Deleting an E-mail Home Schedule Recipient
•
Deleting All E-mail Home Receipts
•
On Demand E-mail Home Status
•
On Demand E-mail Home Configuration
Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-02 Rev A
July 2011
61
Advertisement
Table of Contents
