Teaching The Library (Configuration And Calibration); Running Configuration Teach - Quantum Scalar i6000 User Manual

Hide thumbs Also See for Scalar i6000:

Table of Contents

Chapter 15: Maintaining Your Library

Maintenance Actions

Teaching the Library

(Configuration and

Calibration)

4 Select the tape cartridges you want to use for the firmware update

by checking the check boxes in the media table, and click OK.

Note: You can perform a firmware update only for drives of the

same product (such as HP or IBM), and type (such as LTO-4

5 Click Start.

A message Updating do not power cycle the drive is displayed

above the drive table in red.

Caution: Do not power cycle the drive.

The Status column in the drive table displays the status of the

Caution: The drive firmware image must be compatible with the

drives that you will update with it. For more

information, see the Customer Service Web site.

The Teach command enables you to update the library's stored

configuration and calibration information. Use this command after you

replace a library component or whenever you need to assess the

library's physical configuration (such as the number of modules and I/E

stations, the locations of storage magazines and drives, and the types of

media used in the library) or the position and alignment of library

You can configure the library to automatically perform the full teach

routine (configuration and calibration) whenever the library's power is

cycled. For more information, see

on page 177.

Starting the configuration teach process causes the library to assess its

contents, gathering information as follows:

• Number of modules

Setting Up Policies for the Physical

Quantum Scalar i6000 User's Guide

Troubleshooting