Table 29 Send Email Test - Quantum px720 User Manual

Table 29 Send Email Test

Quantum PX720 User's Guide
Field
Message Type:
Warning
Message Type:
Informational
New
Edit
Remove
Field
Send Test
SNMP
If the customer wishes to use the Quantum PX720 system with a network
framework application such as HP OpenView, or CA Unicenter, the
SNMP configuration must be defined. SNMP stands for Simple Network
Management Protocol, a set of
SNMP works by sending messages, called protocol data units (PDUs), to
Chapter 3 Quantum PX720 Remote Management
Description
When a warning state exists on the Quantum
PX720 system such as an overtemp condition,
an email is sent to everyone on the warning
recipient list.
When an informational event has occurred on
the Quantum PX720 system such as starting
up or shutting down the system, an email is
sent to everyone on the operator access
recipient list.
To add a new recipient to a specific list, type
the email address of the new recipient in the
field and click .
Save
To edit a recipient, select the individual email
address from the list and click
To remove an email notification type from the
E-mail list, select the E-mail type and click
.
Remove
Description
To test the email notification system, click
. An email is sent to the critical
Send Test
e-mail recipients list. If the test email is not
successful, verify the email server information
and the critical recipients list and try again.
protocols for managing complex networks.
Setup
.
Edit
3
140