Xerox DocuColor 2240 Service Manual page 282

12-170 Set Eject
The Compiler Paper Sensor did not deactuate after the Eject Motor energized.
Initial Actions
• Check condition and specification of the paper supply.
• Check for obstructions in the paper feed path.
• Clean the Eject Roll and Eject Pinch Roll and check for wear.
Procedure
Enter dC330 [012-102] and press Start. Open the Top Cover
piler Paper Sensor (PL 17.10) (Figure 1). The display changes.
Y N
Press Stop. Check the circuit of the Compiler Paper Sensor
99-2 RAP for troubleshooting procedure.
Press Stop. Enter dC330 [012-030] and press Start. The Eject Motor
Figure 3).
Y N
Remove the Rear Cover (PL 17.5). +24 VDC is measured between
the Eject Motor and GND.
Y N
+24 VDC is measured between P/J846- 6 and 12 on the Finisher PWB and
GND.
Y N
Replace the Finisher PWB
Check wiring between P/J846- 6 and 12 and P/J881- 2 and 5 for damage or poor
contact.
+24 VDC is measured between P/J881- 1, 3, 4 and 6 on the Eject Motor and GND.
Y N
Replace the Eject Motor (PL 17.8).
Check the wires from P/J846 to P/J881
replace the Finisher PWB (PL 17.13).
Check the following:
• Ensure that the connectors shown in the circuit diagrams
connected and that the wires are not damaged.
• Check the Eject Motor and its associated gears, pulleys and belts
contamination or misalignment.
• Eject Clamp for an up and down movement failure
• Stacker Tray for foreign substance
• Replace the Compiler Paper Sensor
• If the problem persists, replace the Finisher PWB
Initial issue
DC 3535/2240/1632, WC M24
(PL 17.6) and actuate the Com-
(Figure 2). Refer to the
(PL 17.8) energizes
P/J881
(PL 17.13).
for damage or poor contact. If the check is OK,
(Figure 2, Figure 3) are securely
(PL 17.8) for damage,
(PL 17.8).
(PL 17.1).
(PL 17.10).
(PL 17.13) (Figure 4).
Compiler
Paper
Sensor
OF
-2 and 5 on
Figure 2 12-170 RAP Circuit Diagram - Compiler Paper Sensor
09/03
2-249
Figure 1 Component Location
Status Indicator RAPs
12-170