Xerox DocuColor 2240 Service Manual page 280

12-120 Compiler Entrance Sensor On
The Compiler Entrance Sensor did not detect paper.
Initial Actions
• Check condition and specification of the paper supply.
• Check for obstructions in the paper feed path.
• Clean the H Transport Belt and check for wear.
• Check the Guides on the H Transport Cover for damage, wear or faulty installation
Procedure
Enter dC330 [012-101] and press Start. Open the H Transport Cover and actuate the Complier
Entrance Sensor (PL 17.12) (Figure 1) by manually feeding a sheet of paper through the Fin-
isher. The display changes.
Y N
Press Stop. Check the circuit of the Compiler Entrance Sensor
OF 99-2 RAP for troubleshooting procedure.
Press Stop.
• Ensure that the connectors shown in the circuit diagram
nected and that the wires are not damaged.
• Check the Finisher Drive Motor and its associated gears and belts
damage, contamination or misalignment.
• Decurler Roll/Pinch Roll for a drive failure
• Replace the Compiler Entrance Sensor
• If the problem persists, replace the Finisher PWB
Compiler
Entrance
Sensor
Figure 1 Component Location
Initial issue
DC 3535/2240/1632, WC M24
(Figure 2). Refer to the
(Figure 2) are securely con-
(PL 17.4, PL
(PL 17.7).
(PL 17.12).
(PL 17.13) (Figure 3).
Decurler Clutch
Home
Sensor
Figure 2 12-120 RAP Circuit Diagram - Compiler Entrance Sensor
17.7) for
09/03
2-247
Figure 3 Finisher PWB
Status Indicator RAPs
12-120