Xerox DocuColor 2240 Service Manual page 742

OF 99-6 2 Wire Motor Open
Procedure
NOTE: Before performing this RAP, ensure that the motor is free to rotate.
Enter dC330 [XXX-XXX].
Refer to Figure 1. There is +24VDC measured between Pin 3(+) of the PWB and GND(-).
Y N
There is +24VDC measured between the Motor Pin 2(+) of the Motor and GND(-).
Y N
There is +24VDC measured between the Motor Pin 1(+) of the Motor and GND(-).
Y N
There is +24VDC measured between the PWB Pin 4(+) of the PWB and GND(-
).
Y N
Replace the PWB.
Check the wire between the PWB Pin 4 and the Motor Pin 1 for an open circuit
or poor contact.
Replace the motor.
Check the wire between the PWB Pin 3 and the Motor Pin 2 for an open circuit or poor
contact.
Replace the PWB.
Figure 1 OF 99-6 RAP Circuit Diagram - Motor
Initial issue
DC 3535/2240/1632, WC M24
OF 99-7 2 Wire Motor On
Procedure
Turn off the power. Remove the PWB connector. Refer to
less measured between the connector Pin 3 and the frame.
Y N
Replace the PWB.
Check the wire between the connector Pin 3 and the motor Pin 2 for a short circuit.
If the check is OK, replace the motor.
Figure 1 OF 99-7 RAP Circuit Diagram - Motor
09/03
2-709
Figure 1. There is 10 Ohm's or
Status Indicator RAPs
OF 99-6, OF 99-7