REP 9.25 Erase Lamp/Rail (K,Y,M,C)
Parts List on
PL 4.2
Replacement
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
1.
Remove the Dispenser Cover
(REP
2.
Raise the Lever.
3.
Remove the Bracket and Erase Lamp/Rail
1
Disconnect
connector
2
Remove screw (1), Bracket
and Erase Lamp/Rail
Figure 1 Removing the Erase Lam/Rail
Repairs and Adjustments
REP 9.25, REP 9.26
WARNING
9.6).
(Figure
1).
REP 9.26 ATC Sensor
Parts List on
PL 6.2
Removal
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
1.
Remove the Front Cover
(REP
2.
Remove the Drum Cartridges
3.
Remove the Waste Toner Cartridge
4.
Remove the Waste Toner Cartridge Cover
5.
Remove the Fuser Cover
(REP
6.
Remove the Dispenser Cover
7.
Remove all Toner Dispensers
NOTE: In next step, do not remove sensor.
8.
Remove the housing for the Full Toner Sensor
NOTE: In next step, it may not be necessary to disconnect harnesses for Plate Assembly (PL
4.2) to remove a developer housing.
9.
Remove Plate Assembly
(REP
10. Remove Developer Housing
(REP
11. Release Harness from Harness Clips
2
Release Tab and
remove wires
Figure 1 Removing Harness from Clips
09/03
4-98
WARNING
14.7).
(REP
9.1).
(REP
9.4).
(REP
9.3).
14.8).
(REP
9.6).
(REP
9.7).
(REP
9.5).
9.8).
9.9).
(Figure
1).
1
Carefully note the
position of wires
3
Lift Tab and remove wires
DC 3535/2240/1632, WC M24
Initial issue