Xerox DocuColor 2240 Service Manual page 302

12-260 Eject Clamp Home Sensor On
The Eject Clamp Home Sensor does not turn on after the Eject Clamp up started.
Initial Actions
• Check for obstructions in the Clamp area.
Procedure
Remove the Rear Cover (PL 17.5) and the Eject Clamp Home Sensor bracket
sensor connected). Enter dC330 [012-210] and press Start. Actuate the Eject Clamp Home
Sensor (PL 17.8) (Figure 1). The display changes.
Y N
Press Stop. Check the circuit of the Eject Clamp Home Sensor
OF 99-2 RAP for troubleshooting procedure.
Restore mounting of the Eject Clamp Home Sensor. Enter
The Eject Clamp (PL 17.6) moves up.
Y N
The Eject Motor (Figure 3) energized.
Y N
Remove the Rear Cover (PL 17.5). +24 VDC is measured between P/J881- 2 and
5 on the Eject Motor and GND.
Y N
+24 VDC is measured between P/J846- 6 and 12 on the Finisher PWB and
GND.
Y N
Replace the Finisher PWB
Check wiring between P/J846- 6 and 12 and P/J881- 2 and 5 for damage or
poor contact.
+24 VDC is measured between P/J881- 1, 3, 4 and 6 on the Eject Motor and
GND.
Y N
Replace the Eject Motor
Check the wires from P/J846
OK, replace the Finisher PWB
Check the Eject Motor and its associated gears, pulleys and belts
contamination and misalignment.
Press Stop.
• Ensure that the connectors shown in the circuit diagrams
connected and that the wires are not damaged.
• Replace the Eject Clamp Home Sensor
• If the problem persists, replace the Finisher PWB
Initial issue
DC 3535/2240/1632, WC M24
(PL
(Figure 2). Refer to the
dC330 [012-034] and press Start.
(PL 17.13).
(PL 17.8).
to P/J881 for damage or poor contact. If the check is
(PL 17.13).
(PL 17.8) for damage,
(Figure 2, Figure 3) are securely
(PL 17.8).
(PL 17.13) (Figure 4).
Eject Clamp Home Sensor
17.8) (leave
Figure 2 12-260 RAP Circuit Diagram - Eject Clamp Home Sensor
09/03
2-269
Figure 1 Component Location
Status Indicator RAPs
12-260