Xerox DocuColor 2240 Service Manual page 953

4. Select the Center Setup button.
5. Select Start.
Make sure not to hook the wiring harness when moving the MOB Sensor.
6. If Center Setup is OK, dC685 is complete. Use the Cleaning Tool to pull the MOB Sensor
back to the original position, and fasten the screw.
If Center Setup fails, ensure MOB Sensor is positioned to the rear. Go back to step 1 of
the Center check.
Check the Rough Skew Setup
1. Select the Skew (Rough) Setup button.
2. Select Start.
3. Check the Judgement window. If NG is displayed, set the values in NVM locations 760-
019 through 760-022 to either the default value (236) or the value recorded on the NVM
list in Tray 1 if available. Repeat steps 1 and 2.
If NG is still displayed, there is a problem with the ROS, the IBT Assembly, or the MOB
Sensor.
4. If OK is displayed in the Judgement window, check the Skew Correction row in the
Skew Values window. If a value greater than 1 is displayed for any color, perform the
Adjustment, then repeat the Fine Skew Setup check.
Adjustment
1. In the Skew Values window, record the value for each color in the Skew Correction row.
This is the required number of rotations of the adjustment screw.
To avoid exposure to laser light, reinstall the Waste Cartridge before attempting to
recheck the adjustment.
2. Remove the Waste Toner Cartridge
3. For each color, rotate the appropriate (CYMK) adjustment screw
(CCW) direction the number of clicks recorded in step 1.
Repairs and Adjustments
ADJ 9.6
CAUTION
WARNING
(REP 9.4).
(Figure 2) in + (CW), or -
Figure 2 Adjusting Skew
4. Reinstall Waste Toner Cartridge
Check IOT Lead Edge/Side Edge (ADJ
09/03
4-170
(REP 9.4).
9.9) after performing this adjustment.
DC 3535/2240/1632, WC M24
Initial issue