Rep 1.17 Vsel Pwb - Xerox DocuColor 2240 Service Manual

REP 1.17 VSEL PWB

Parts List on PL 13.1
Removal
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine
PWBs can be damaged by electrostatic discharge. Observe all ESD procedures.
1. Remove Right Cover (REP 14.3).
2. Remove Top Cover (REP 14.1).
3. Remove Rear Cover (REP 14.2).
4. Remove the ESS Top Cover (PL 13.1).
Protect the Hard Drive Harness. The Hard Drive is mounted to the ESS Top Cover; the
harness remains connected to the ESS PWB while removing the cover.
a. Remove screws (11) from the ESS Top Cover.
b. Lift ESS Top Cover and place it upside down on the toner cartridges.
c. Disconnect the Hard Drive Harness from the ESS PWB.
5. Remove the mating connector screws (8) and screws (2) securing the jacks to the plate
(Figure 1).
1
Remove mating connector screws (8)
Figure 1 Removing mating connector screws and screws.
Repairs and Adjustments
REP 1.17
WARNING
CAUTION
CAUTION
2
Remove
screws (2)
6. Remove the ESS PWB (Figure
3
Disconnect P300/NJ300. Lift ESS straight up to disconnect P/J460.
Figure 2 Removing the ESS PWB
7. Remove the bracket over the VSEL PWB
Figure 3 Removing Bracket
8. Remove the VSEL PWB (Figure
09/03
4-16
2).
(Figure 3).
1
Remove
screws
(4)
4).
DC 3535/2240/1632, WC M24
1
Disconnect
P/J310
2
Remove
screws (7)
Initial issue