Rep 9.21 Left Lift Assembly - Xerox DocuColor 2240 Service Manual

11. Remove Right Lift Assembly (Figure
a. Remove Auger mounting screws (2).
b. Remove lift position screw.
c. Remove secondary position screw.
d. Remove lower screws (2).
e. Remove Right Lift Assembly.
Auger
Mounting
Screws (2)
Lift Position
Screw
Figure 2 Removing Right Lift Assembly
Replacement
Move Lever to down position before reinstalling IBT Belt Assembly.
Initial issue
DC 3535/2240/1632, WC M24
2).
Lift Secondary
Position Screw
Lower Screws (2)

REP 9.21 Left Lift Assembly

Parts List on PL 5.1
Removal
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
1. Remove Front Cover (REP 14.7).
2. Remove Lever (REP 9.18).
3. Remove Rear Cover (REP 14.2).
4. Remove Left Lower Cover Assembly
5. Remove Tray 5 (REP 7.1).
6. Remove Left Cover Assembly
7. Optional for improved visibility: Remove Fuser
8. Remove Registration Transport Assembly
9. Remove MOB Sensor (REP 9.14).
10. Remove the Duct (PL 8.1, item 7).
11. Remove Left Hinge (REP 9.19).
12. Remove Cyan and Black Toner Cartridges.
13. Remove Cyan and Black Toner Dispensers
NOTE: In next step, do not remove the Full Toner Sensor from the sensor housing
In next step, it may not be necessary to disconnect harnesses for Plate Assembly
remove a developer housing.
14. Remove Plate Assembly (REP
15. Remove Cyan and Black Developer Housings
16. Remove Left Lift Assembly (Figure
NOTE: In next step, use a magnet to capture E-Ring and Washer while removing them.
a. From inside Developer Housing cavity, remove e-ring and washer from each end of
Left Lift.
b. Remove screws (4).
c. Remove Left Lift Assembly.
NOTE: Maintain orientation to ensure bearings (2) and washers (2) do not fall off
posts.
09/03
4-89
WARNING
(REP 14.6).
(REP 8.1).
(REP 10.1).
(REP 8.6).
(REP 9.7).
9.8).
(REP 9.9).
1).
Repairs and Adjustments
REP 9.20, REP 9.21
(PL 4.2) to