Eject Clamp Home Sensor Off - Xerox DocuColor 2240 Service Manual

12-262 Eject Clamp Home Sensor Off

The Eject Clamp Home Sensor does not turn off within 200ms after the Eject Clamp DOWN
has started.
Procedure
Remove the Rear Cover (PL 17.5) and the Eject Clamp Home Sensor bracket
sensor connected). Enter dC330 [012-210] and press Start. Actuate the Eject Clamp Home
Sensor (PL 17.8) (Figure 1). The display changes.
Y N
Press Stop. Check the Eject Clamp Home Sensor components for mechanical problems.
If the components are good, check the circuit of the Eject Clamp Home Sensor
Refer to the OF 99-2 RAP for troubleshooting procedure
Press Stop. Restore mounting of the Eject Clamp Home Sensor. Enter
press Start. The Eject Clamp (PL 17.6) moves down.
Y N
The Eject Motor (Figure 3) energized.
Y N
Remove the Rear Cover (PL 17.5). +24 VDC is measured between P/J881- 2 and
5 on the Eject Motor and GND.
Y N
+24 VDC is measured between P/J846- 6 and 12 on the Finisher PWB and
GND.
Y N
Replace the Finisher PWB
Check wiring between P/J846- 6 and 12 and P/J881- 2 and 5 for damage or
poor contact.
+24 VDC is measured between P/J881- 1, 3, 4 and 6 on the Eject Motor and
GND.
Y N
Replace the Eject Motor
Check the wires from P/J846
is OK, replace the Finisher PWB
Check the Eject Motor and its associated gears, pulleys and belts
contamination and misalignment.
Press Stop.
• Ensure that the connectors shown in the circuit diagrams
connected and that the wires are not damaged.
• Replace the Eject Clamp Home Sensor
• If the problem persists, replace the Finisher PWB
Initial issue
DC 3535/2240/1632, WC M24
(PL
dC330
(PL 17.13).
(PL 17.8).
to P/J881 for an damage or poor contact. If the check
(PL 17.13).
(PL 17.8) for damage,
(Figure 2, Figure 3) are securely
(PL 17.8).
(PL 17.13) (Figure 4).
Eject Clamp Home Sensor
17.8) (leave
(Figure 2).
[012-032] and
Figure 2 12-262 RAP Circuit Diagram - Eject Clamp Home Sensor
09/03
2-271
Figure 1 Component Location
Status Indicator RAPs
12-262