7-954 Tray 5 Size Mismatch (Slow Scan Direction)
The paper in the slow scan direction is shorter than the specified paper size.
Procedure
The correct size paper is loaded in the Tray 5.
Y
N
Load the correct size paper.
Replace the Registration Sensor
(PL
2.6).
Status Indicator RAPs
7-954, 7-959
7-959 Tray 5 Paper Mismatch 1
Incorrect type of transparency detected by the OHP sensor.
Initial Actions
•
Ensure that only approved transparencies (no white strip) are used.
•
Check that the transparencies are oriented correctly.
•
Check for obstructions and clean the OHP Sensor.
Procedure
Open the Left Cover Assembly
(PL
OHP Sensor R
(PL
2.6) using a plain sheet of paper. The display changes.
Y
N
Press Stop. Check the circuit of the OHP Sensor
troubleshooting procedure.
Press Stop.
•
Ensure that the connectors shown in the circuit diagram
nected and that the wires are not damaged.
•
If the problem persists, replace the MCU PWB
Figure 1 7-959 RAP Circuit Diagram - OHP Sensor R
09/03
2-154
2.9). Enter
dC330
[008-110] and press Start. Block the
(Figure
1). Refer to the
(Figure
1) are securely con-
(PL
13.1).
DC 3535/2240/1632, WC M24
OF 99-1
RAP for
Initial issue