4.
Check vertical magnification
(Figure
Measure the 300mm line running from near LE1 to the trail edge of the 1.8lp ladder. If the
dimension is not 300mm ±1.5mm, perform the Adjustment.
Lead Edge
300mm +/-
1.5mm
Figure 2 Checking Vertical Magnification
Adjustment
1.
Horizontal Magnification Adjustment
•
Enter
dC131
[715-234]
•
Each bit represents 0.1% change:
Increase the value to lengthen the line
Decrease the value to shorten the line
2.
Vertical Magnification Adjustment
•
Enter
dC131
[715-302]
•
Each bit represents 0.1% change:
Increase the value to lengthen the line
Decrease the value to shorten the line
Repairs and Adjustments
ADJ 9.12
2):
09/03
4-178
Initial issue
DC 3535/2240/1632, WC M24