Xerox DocuColor 2240 Service Manual page 178

Hide thumbs Also See for DocuColor 2240:
Table of Contents

Advertisement

7-283 Tray 3 Lift (3TM)
The Tray 3 Level Sensor does not detect tray lift.
Initial Actions
Remove Tray 3 from the machine and empty the paper stock, then:
Manually turn the gear at the rear of Tray 3 to check that the Bottom Plate moves up and
down smoothly.
Check that the Tray 3 Level Sensor Actuator
smoothly.
Gently push Tray 3 in to check that the drive transmission is firmly engaged.
Ensure that Tray 3 is properly closed.
Procedure
Enter
dC330
[008-006] and press Start. The Tray 3 Feed/Lift Motor
Y
N
Press Stop. Check the circuit of the Tray 3 Feed/Lift Motor
from the Tray Module PWB to the Tray 3 Feed/Lift Motor for an open circuit. If the wires
are good, replace the Tray 3 Feed/Lift Motor
the Tray Module PWB
(PL
15.9)
Press Stop. Enter
dC330
[007-118] and press Start. Open and close Tray 3. The display
changes.
Y
N
Press Stop. Check the circuit of the Tray 3 Level Sensor
RAP for troubleshooting procedure.
Press Stop.
Check the Tray 3 Feed/Lift Motor and its associated gears
ination or misalignment.
Ensure that the connectors shown in the circuit diagrams
connected and that the wires are not damaged.
Replace the Tray 3 Level Sensor
(PL
If the problem persists, replace the Tray Module PWB
Initial issue
DC 3535/2240/1632, WC M24
(PL
15.5) is properly seated and operates
(PL
15.5) energizes.
(Figure
1). Check the wires
(PL
15.5). If the problem still exits, replace
(Figure
2). Refer to the
(PL
15.5) for damage, contam-
(Figure
1,
Figure
2) are securely
15.5).
(PL
15.9).
OF 99-2
Figure 1 7-283 RAP Circuit Diagram - Tray 3 Feed/Lift Motor (3TM)
Figure 2 7-283 RAP Circuit Diagram - Tray 3 Level Sensor (3TM)
09/03
2-145
Status Indicator RAPs
7-283

Advertisement

Table of Contents
loading

This manual is also suitable for:

Docucolor 3535Docucolor 1632Workcentre m24

Table of Contents