Xerox DocuColor 2240 Service Manual page 288

Hide thumbs Also See for DocuColor 2240:
Table of Contents

Advertisement

12-244 Staple Home Sensor
The Staple Head Home Sensor did not actuate after the Stapler Motor energized to open the
Stapler.
Procedure
Enter
dC330
[012-207] and press Start. Turn the Staple Motor Gear manually to actuate the
Staple Head Home Sensor. The display changes.
Y
N
+5 VDC is measured at Stapler Assembly between P/J886-5 and P/J886-1.
Y
N
+5 VDC is measured at the Finisher PWB between P/J852-1 and P/J852-5.
Y
N
Replace the Finisher PWB
Check the wire between the Finisher PWB
J886
for an open circuit or poor contact.
Turn the Staple Motor Gear manually to deactuate and actuate the Staple Head Home
Sensor. The voltage changes between the Stapler P/J886-4 and Finisher Frame.
Y
N
Switch off the power. Disconnect
on. +5 VDC is measured at the Finisher PWB P852-2.
Y
N
Replace the Finisher PWB
Check the wires between the Finisher
obvious damage
(Figure
2).
If the wires are good, replace the Stapler Assembly
Replace the Finisher PWB
(PL
17.13).
Position paper in stapler
(Figure
1). Enter
Motor
(PL
17.9) energizes
(Figure
3).
Y
N
With [012-020] running, +24 VDC is measured at the Finisher PWB P/J847-7.
Y
N
Replace the Finisher PWB
(PL
Check continuity between:
The Finisher PWB P/J847-7 and Stapler Assembly P/J887-1
The Finisher PWB P/J847-8 and Stapler Assembly P/J887-2
The Finisher PWB P/J847-9 and Stapler Assembly P/J887-3
The Finisher PWB P/J847-10 and Stapler Assembly P/J887-4
If no problems are found, replace the Stapler Assembly
If the problem continues, replace the Finisher PWB
Replace the Finisher PWB
(PL
17.13).
Initial issue
DC 3535/2240/1632, WC M24
(PL
17.13)
(Figure
4).
P/J852
and the Stapler Assembly
P/J852
on the Finisher PWB. Switch the power
(PL
17.13).
P/J852
and the Stapler Assembly
(PL
17.9).
dC330
[012-020] and press Start. The Staple
17.13).
(PL
17.9).
(PL
17.13).
P/
P/J886
for
Figure 2 12-244 RAP Circuit Diagram - Staple Head Home Sensor
Figure 3 12-244 RAP Circuit Diagram - Staple Motor
09/03
2-255
Stapler
Assembly
Figure 1 Component Location
Status Indicator RAPs
12-244

Advertisement

Table of Contents
loading

This manual is also suitable for:

Docucolor 3535Docucolor 1632Workcentre m24

Table of Contents