12-122 Compiler Entrance Sensor Off
Paper does not deactuate the Compiler Entrance Sensor.
Initial Actions
•
Check condition and specification of the paper supply.
•
Check for obstructions in the paper feed path.
•
Clean the H Transport Belt and check for wear.
Procedure
Make a copy and observe paper in the Compiler Tray. The copy enters the Compiler Tray.
Y
N
There is a drives problem. Check the following:
•
The Finisher Drive Motor and its associated gears and belts
contamination or misalignment.
•
The Decurler Roll/Pinch Roll (Shaft)
•
The Exit Roll and Pinch Rolls
Enter
dC330
[012-101] and press Start. Open the H Transport Cover and actuate the Complier
Entrance Sensor
(PL
17.12)
(Figure
1) by manually feeding a sheet of paper through the Fin-
isher. The display changes.
Y
N
Press Stop. Check the circuit of the Compiler Entrance Sensor
OF 99-2
RAP for troubleshooting procedure.
Press Stop.
•
Ensure that the connectors shown in the circuit diagram
nected and that the wires are not damaged.
•
Replace the Compiler Entrance Sensor
•
If the problem persists, replace the Finisher PWB
Compiler
Entrance
Sensor
Figure 1 Component Location
Status Indicator RAPs
12-122
(PL
17.7) for damage,
(PL
17.7) for a drive or contact failure.
(PL
17.12) for a drive or contact failure.
(Figure
2). Refer to the
(Figure
2) are securely con-
(PL
17.12).
(PL
17.13)
(Figure
3).
Decurler Clutch
Figure 2 12-122 RAP Circuit Diagram - Compiler Entrance Sensor
Home
Sensor
09/03
2-248
Initial issue
DC 3535/2240/1632, WC M24