Xerox DocuColor 2240 Service Manual page 935

Adjustment
1. Adjust Side 1 DADF Side Registration.
a. Enter NVM Rear/Write (dC131) [715-015].
NOTE: Increasing value moves side edge metrics SE1 through SE4 toward edge.
b. If B is more than A, increase the NVM value (15 = approx. 1 mm).
If B is less than A, decrease the NVM value (15 = approx. 1 mm).
c. Check results of adjustment and adjust if required.
2. Adjust Side 2 DADF Side Registration.
a. Enter NVM Rear/Write (dC131) [715-128].
NOTE: Increasing value moves side edge metrics SE1 through SE4 toward edge.
b. If copy 2 edge metric is farther away from edge than copy 1, increase the NVM value
(15 = approx. 1 mm).
If copy 2 edge metric is closer to edge than copy 1, decrease the NVM value (15 =
approx. 1 mm).
c. Check results of adjustment and adjust as required.
NOTE: 2 to 2-sided or 2 to 1-sided must be selected to view a change in [715-128].
[715-128] produces no change in 1 to 2-sided copying.
NOTE: Total lead edge deviation for DADF is ±1.6 mm. Total lead edge deviation for IIT is
±0.5 mm. This leaves ±1.1 mm for DADF when a copy paper test pattern is made for use in
DADF.
Repairs and Adjustments
ADJ 5.1
09/03
4-152
Initial issue
DC 3535/2240/1632, WC M24