Configuring Habp Client; Displaying And Debugging Habp Attribute - Huawei Quidway S3500 Series Operation Manual

Operation Manual - Security
Quidway S3500 Series Ethernet Switches
Table 5-1 Configuring HABP server
Enable HABP attribute
Restore HABP attribute to the default value
Configure the switch as HABP Server
Delete HABP Server configuration
Set time interval for HABP request transmission
Restore the time interval to the default value
By default, HABP attribute is disabled at a switch, the HABP mode is client, and the
time interval for HABP request transmission is 20 seconds.

5.2.2 Configuring HABP Client

HABP client runs at the member switches. Since the default HABP mode is client, you
only need to enable HABP attribute at a switch.
Please perform the following operations in system view.
Table 5-2 Configuring HABP client
Enable HABP attribute
Restore HABP to the default value
By default, HABP attribute is disabled at a switch.

5.3 Displaying and Debugging HABP Attribute

After the above configurations, you can view HABP attribute information using the
display command in any view, or just for check. You can also debug HABP module
using the debugging command in user view.
Table 5-3 Displaying and debugging HABP attribute
Display configuration information and state of
HABP attribute
Display MAC address table of HABP attribute
Display HABP packet statistics
Display HABP debugging state
Operation
Operation
Operation
Huawei Technologies Proprietary
5-2
Chapter 5 HABP Configuration
habp enable
undo habp enable
habp server vlan vlan-id
undo habp server
habp timer interval
undo habp timer
Command
habp enable
undo habp enable
display habp
display habp table
display habp traffic
display debugging habp
Command
Command