Rule (Ipv4 Advanced Acl View) - HP 6125G Command Reference Manual

NOTE:
The lsap keyword is not supported if the ACL is for QoS traffic classification or packet filtering.
Examples
# Create a rule in ACL 4000 to permit ARP packets and deny RARP packets.
<Sysname> system-view
[Sysname] acl number 4000
[Sysname-acl-ethernetframe-4000] rule permit type 0806 ffff
[Sysname-acl-ethernetframe-4000] rule deny type 8035 ffff

rule (IPv4 advanced ACL view)

Syntax
rule [ rule-id ] { deny | permit } protocol [ { { ack ack-value | fin fin-value | psh psh-value | rst rst-value
| syn syn-value | urg urg-value } * | established } | counting | destination { dest-addr dest-wildcard |
any } | destination-port operator port1 [ port2 ] | dscp dscp | fragment | icmp-type { icmp-type
[ icmp-code ] | icmp-message } | precedence precedence | source { sour-addr sour-wildcard | any } |
source-port operator port1 [ port2 ] | time-range time-range-name | tos tos | vpn-instance
vpn-instance-name ] *
undo rule rule-id [ { { ack | fin | psh | rst | syn | urg } * | established } | counting | destination |
destination-port | dscp | fragment | icmp-type | precedence | source | source-port | time-range | tos
| vpn-instance ] *
View
IPv4 advanced ACL view
Default level
2: System level
Parameters
rule-id: Specifies a rule ID, in the range of 0 to 65534. If no rule ID is provided when you create an ACL
rule, the system automatically assigns it a rule ID. This rule ID takes the nearest higher multiple of the
numbering step to the current highest rule ID, starting from 0. For example, if the rule numbering step is
5 and the current highest rule ID is 28, the rule is numbered 30.
deny: Denies matching packets.
permit: Allows matching packets to pass.
protocol: Protocol carried by IPv4. It can be a number in the range of 0 to 255, or in words, gre (47),
icmp (1), igmp (2), ip, ipinip (4), ospf (89), tcp (6), or udp (17).
can specify regardless of the value that the protocol argument takes.
Table 6
18
describes the parameters that you