Protocols And Standards; Rip Configuration Task List - HP 3600 v2 series Configuration Manual

Protocols and standards

RFC 1058, Routing Information Protocol
•
RFC 1723, RIP Version 2 - Carrying Additional Information
•
RFC 1721, RIP Version 2 Protocol Analysis
•
• RFC 1722, RIP Version 2 Protocol Applicability Statement
RFC 1724, RIP Version 2 MIB Extension
•
RFC 2082, RIPv2 MD5 Authentication
•
RFC 2453, RIP Version 2
•

RIP configuration task list

Complete the following tasks to configure RIP:
Task
Configuring RIP basic functions
Configuring RIP route
control
Tuning and optimizing
RIP networks
Configuring RIP FRR
Configuring BFD for RIP
Configuring an additional routing metric
Configuring RIPv2 route summarization
Disabling host route reception
Advertising a default route
Configuring inbound or outbound route filtering
Configuring a priority for RIP
Configuring RIP route redistribution
Configuring RIP timers
Configuring split horizon and poison reverse
Configuring the maximum number of load
balanced routes
Enabling zero field check on incoming RIPv1
messages
Enabling source IP address check on incoming RIP
updates
Configuring RIPv2 message authentication
Specifying a RIP neighbor
Configuring RIP-to-MIB binding
Configuring the RIP packet sending rate
Single-hop detection in BFD echo packet mode
Bidirectional detection in BFD control packet mode
24
Remarks
Required
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional