Installing Left-Side Components - Arctic Cat 2016 90 Utility Service Manual

4. Remove the centrifugal clutch housing; then remove
the centrifugal clutch shoe/driven pulley assembly.
YT022
5. Remove the starter reduction gear shield; then
remove the starter countershaft housing. Account for
a thrust washer (A) and countershaft (B).
YT024A
NOTE: The thrust washer and countershaft may

come out with the countershaft housing.
6. Remove the starter one-way nut using Starter One-
Way Clutch Nut Wrench (p/n 0444-191); then install
Starter One-Way Clutch Puller (p/n 0444-188) to the
one-way housing.
YT104
7. Install the push-bolt into the puller; then using two
wrenches as illustrated, tighten the push-bolt until
the one-way clutch is free of the crankshaft.
38
YT104
 NOTE: It may be necessary to strike the head of the
bolt sharply with a hammer after tightening to free
the one-way housing from the crankshaft.
8. Make sure the transmission is in neutral; then
remove the gear position switch noting the orienta-
tion of the drive pin. Account for an O-ring.
YT028
Installing Left-Side
Components
A. GEAR POSITION SWITCH
B. STARTER ONE-WAY CLUTCH
C. ROTOR/FLYWHEEL
D. CENTRIFUGAL CLUTCH
E. V-BELT/DRIVE CLUTCH/DRIVEN
PULLEY
1. With the transmission in neutral, install a new O-ring
on the gear position switch; then orient the pin as
shown and install the switch into the gear case.
Secure with a cap screw and tighten securely.