Installing Left-Side Components - Arctic Cat Wildcat ROV 2013 Service Manual

2. Thoroughly clean the gear hub; then apply a drop of
green Loctite #620 to the bearing outer race and press
into the gear hub until even with the lower chamfer
radius.
INSPECTING STATOR COIL/
MAGNETO COVER ASSEMBLY
1. Inspect the stator coil for burned or discolored wiring,
broken or missing hold-down clips, or loose cap
screws.
2. Inspect the bearings in the magneto housing for dis-
coloration, roughness when rotated, and secure fit in
bearing bores.
REPLACING STATOR COIL/
CRANKSHAFT POSITION SENSOR
1. Remove the three cap screws securing the stator coil,
two cap screws securing the crankshaft position sen-
sor, and two cap screws from the harness hold-down.
2. Lift the rubber grommet out of the housing; then
remove the stator coil/crankshaft position sensor.
Account for and note the position of the harness hold-
down under the crankshaft position sensor.
50
FI583
3. Install the new stator coil assembly and secure with
three cap screws using a drop of red Loctite #271 on
each. Tighten according to the chart.
FI580
Cover
Original
New
4. Place the stator wire harness hold-down into position;
then install the crankshaft position sensor and secure
with two cap screws. Tighten securely.
5. Install the upper cable hold-down and secure with the
cap screws. Tighten securely.
Installing Left-Side
Components
1. Thoroughly clean all gasket material and sealant from
mating surfaces.
Bolt Type ft-lb
Hex-Head 11
Hex-Head 13
H2-017A
H2-027
N-m
15
18
H2-017