Installing Right-Side Components - Arctic Cat DVX 400 2008 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
4. From the right side, install the eight case half cap
screws (three inside the case); then tighten only
until snug.
NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
5. In a crisscross/case-to-case pattern, tighten the cap
screws (from steps 3-4) until the halves are cor-
rectly joined; then tighten to specifications (see
Section 10).
NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs.
www.mymowerparts.com
Back
SP230
SP229
CC095D
Back to TOC
Installing Right-Side
Components
NOTE: Critical torque specifications are located
in Section 10.
A. Primary Drive Gear
B. Crank Balancer Gear
C. Cam Chain
NOTE: It will be necessary to install the starter
driven gear, starter one-way clutch, and the
rotor/flywheel on the left side prior to installing
right-side components. This is done to provide a
means of holding shafts for tightening right-side
shaft nuts.
1. Install the starter driven gear (1) and the key (2);
then clean any oil or grease from the tapered por-
tion of the crankshaft and from inside the rotor/fly-
wheel tapered bore.
2. Align the keyway with the key and install the
rotor/flywheel; then using an offset 27 mm
wrench, hold the flywheel and tighten the nut to
specifications.
3. Install the pins (1); then install the crank balancer
drive gear (2). Install the key (3) and cam chain
drive sprocket (4).
Back to Section TOC
3
SP231
SP232
Next
3-33