Oil Pump; Installing Right-Side Components - Arctic Cat 2012 DVX 90 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
7. Inspect the detent spring and ball. Replace any worn
or broken component.
8. Examine the transmission case and cover for cracks,
discoloration, or chipped bearing bosses.

OIL PUMP

1. Inspect the pump for damage.
2. If the oil pump is damaged, it must be replaced.
 NOTE: The oil pump is a non-serviceable compo-
nent and must be replaced as a complete assembly.
Installing Right-Side
Components
 NOTE: For steps 1-3, refer to illustration YT100C.
36
www.mymowerparts.com
A. MAIN SHAFT
1. Install the non-splined reverse thrust washer (A) on
the main shaft; then install the reverse gear (B) and
splined thrust washer (C). Secure with the snap ring
(D) pressing firmly toward the reverse gear to seat in
the groove.
YT065
2. Install the forward/reverse shift dog (E), forward
gear thrust washer (F), and forward gear bushing
(G); then install the forward gear with the flat side
toward the shift dog.
YT064B
3. Install the forward gear thrust washer (H) and the
spacer (I).
The main shaft is now ready for installation into the
transmission.
B. TRANSMISSION
Assembling
1. Install new oil seals in the transmission case and
cover; then coat the inner surfaces of the seals with
multi-purpose grease.
2. Making sure the bearing is properly aligned in the
transmission case, drive the input driveshaft and
bearing into place with a plastic mallet.
YT100C
Manual
Table of Contents
AT THIS POINT

YT080
YT084A