Viewing Network Settings; Viewing The Date, Time, And Time Zone; Viewing Licenses - Quantum scalar i40 User Manual

Chapter 8: Getting Information About the Library
Viewing Library Information on the Operator Panel
Viewing Network
Settings
Viewing the Date, Time,
and Time Zone

Viewing Licenses

232
Operator Panel
1 Select Reports > Tape Drives.
2 If the library contains more than one tape drive, use the Up and
Down buttons to select a tape drive and press Select.
A short report on the operator panel displays the library's network
settings: host name, IP address, and network configuration.
Operator Panel
1 Select Reports > Network Settings.
2 If IPv6 is enabled, the IPv4 information is shown on the first screen.
Press Next to see the IPv6 address information on the next two or
more screens. Although the library can have unlimited IPv6 address,
a maximum of three are shown in this report.
The operator panel displays the current date, time and time zone
configured on the library.
Operator Panel
Select Reports > Date/Time.
The operator panel displays a list of all the licenses currently installed on
the library: number of COD slots licensed, number of unlicensed slots,
and whether Advanced Reporting is licensed.
Operator Panel
Select Reports > Licenses.
Quantum Scalar i40 and Scalar i80 User's Guide