Configuring The Media Integrity Analysis Report - Quantum scalar i40 User Manual

Chapter 5: Advanced Reporting
Using Advanced Reporting Reports
Configuring the Media
Integrity Analysis
Report
Quantum Scalar i40 and Scalar i80 User's Guide
• Grouping — Specifies which tape drive(s) or partition(s) to
include in the report. Select one of the following:
• All Drives by Coordinate (default) — Presents the sum total
of the selected attribute for all tape drives according to their
location in the library. If more than one tape drive resided in
that location during the selected range, then the attribute
values for all the tape drives that resided in that location are
combined in the chart.
• All Drives by Physical SN — Presents the sum total of the
selected attribute for all drives according to the physical
tape drive serial number.
• All Partitions — Presents a comparison of all drives grouped
by partition in the physical library.
• Selected Drive by Coordinate — The report chart is based on
an individual tape drive location in the library. If more than
one tape drive resided in that location during the selected
range, then the attribute values for all the tape drives that
resided in that location are combined in the chart.
• Selected Drive by Physical SN — The report chart is based on
an individual tape drive identified by its physical drive serial
number.
• Selected Partition — The report chart is based on an
individual partition in the physical library.
Note: See Installed Tape Drive Location Coordinates
page 10 for an explanation of the location coordinates.
3 Click
.
Next
The report is generated and displays on the screen.
This report provides TapeAlert counts for various combinations of tape
drives, tape cartridges, and TapeAlert flags. You can use this report to
help determine if a problem is due to a specific tape drive or tape
cartridge.
Quantum Scalar i40 and Scalar i80 User's Guide
on