Snmp; Smi-S - Quantum scalar i40 User Manual

Chapter 4: Configuring the Library
Configuring System Settings

SNMP

SMI-S

100
4 Make another selection or press Exit.
5 Save the library configuration (see
on page 106).
Enables or disables SNMP traffic to the library. This setting is enabled by
default.
Operator Panel
1 Select Setup > System Settings >SNMP.
2 Select the setting you want to modify and press Modify.
3 Use the Up and Down buttons to select Enabled or Disabled and
press Apply.
4 When finished making all changes, press Exit.
5 Save the library configuration (see
on page 106).
Allows you to enable or disable SMI-S running on the library. This
setting is disabled by default.
Operator Panel
1 Select Setup > System Settings > SMI-S.
2 Press Modify.
3 Use the Up and Down buttons to select Enabled or Disabled and
press Apply.
4 Make another selection or press Exit.
5 Save the library configuration (see
on page 106).
Saving the Library Configuration
Saving the Library Configuration
Saving the Library Configuration
Quantum Scalar i40 and Scalar i80 User's Guide