Viewing Tape Drive Information; Viewing Network Settings - Quantum Scalar i40 User Manual

Chapter 8: Getting Information About the Library
Viewing Library Information on the Operator Panel
Viewing Tape Drive
Information
Viewing Network
Settings
222
• Number of I/E station slots containing a tape cartridge assigned to
the partition
Operator Panel
1 Select Reports > Partitions.
2 If the library contains more than one partition, use the Up and
Down buttons to select a partition and press Select.
The operator panel provides an overview of tape drive information. For
each installed tape drive, you can see the following information:
• Online/offline mode
• Partition to which the tape drive is assigned
• Whether the tape drive is the control path for the partition
• State (ready/active/mounted)
• WWNN (if Fibre Channel) or SAS address (if SAS)
Operator Panel
1 Select Reports > Tape Drives.
2 If the library contains more than one tape drive, use the Up and
Down buttons to select a tape drive and press Select.
A short report on the operator panel displays the library's network
settings: host name, IP address, and network configuration.
Operator Panel
1 Select Reports > Network Settings.
2 If IPv6 is enabled, the IPv4 information is shown on the first screen.
Press Next to see the IPv6 address information on the next two or
more screens. Although the library can have unlimited IPv6 address,
a maximum of three are shown in this report.
Quantum Scalar i40 and Scalar i80 User's Guide