Default Configuration; Configuring Network Settings - Quantum scalar i40 User Manual

Chapter 4: Configuring the Library

Default Configuration

Default Configuration

Configuring Network Settings

38
The library comes with a default configuration, which you can modify at
any time. The default configuration is as follows:
Feature
Library host name
Network settings
Number of partitions
Number of I/E station slots
Number of cleaning slots
The operator panel Setup Wizard allows you to configure network
settings that allow remote access to the library from the Web client. At a
minimum, you must initially configure the network IP address from the
operator panel. After the initial configuration, you can modify the
network settings from either the operator panel or the Web client.
Default Configuration
library
IPv4, DHCP enabled
IPv6 disabled
Equal to the number of unique tape
drives — based on interface type (Fibre
Channel or SAS) and drive generation
(LTO-4 and higher as applicable) — not
currently assigned to a partition.
Storage slots are divided equally
among the partitions.
5
0
Quantum Scalar i40 and Scalar i80 User's Guide