Configuring Control Paths - Quantum scalar i40 User Manual

Chapter 4: Configuring the Library

Configuring Control Paths

Configuring Control Paths
66
Operator Panel
1 Select Setup > Tape Drives (FC).
2 If more than one Fibre Channel tape drive is installed, use the Up
and Down buttons to select a tape drive and press Select.
3 Use the Up and Down buttons to select the item to configure
(Speed, Topology, or Loop ID) and press Modify.
4 Use the Up and Down buttons to scroll through the list of options
until you reach the one you want, then press Apply.
5 Continue to modify as above. When finished, press Exit.
6 Save the library configuration (see
on page 106).
Web Client
1 Select Setup > Drive Settings.
2 View the SAS tape drive settings, if desired.
3 Make changes to any of the Fibre Channel tape drive settings by
using the drop-down lists to select new values.
4 Click Apply.
5 Save the library configuration (see
on page 106).
A control path is the connection between a partition and host
application. The control path connection is made through a designated
tape drive.
When you create a partition, the library automatically assigns the first
tape drive in the partition as the control path. You can modify the
control path at any time.
Only one tape drive can be selected as the control path per partition. In
the event that the tape drive control path connection to the host
Saving the Library Configuration
Saving the Library Configuration
Quantum Scalar i40 and Scalar i80 User's Guide