Setting The Date And Time Manually; Setting The Date And Time Using The Network Time Protocol; Screen - Quantum scalar i40 User Manual

Setting the Date and
Time Manually
Setting the Date and
Time Using the Network
Time Protocol
Quantum Scalar i40 and Scalar i80 User's Guide
Date and time settings are used to log the date and time events take
place and to set the time for automatic backup and restore functions. At
a minimum, you should set the library's date and time as part of the
initial library configuration.
The time is set to a 24 hour clock. For example, four o'clock in the
afternoon is entered as 16:00.
Operator Panel
1 Select Setup > Date & Time.
2 Modify the date and time using the method described in
and Editing on the Operator Panel
Web Client
1 Select Setup > Date & Time.
2 Refer to the library Web client online help for detailed instructions.
To view the help, click the Help icon in the upper right corner of the

screen.

The library supports the Network Time Protocol (NTP). NTP allows you to
synchronize the library date and time with other components in your IT
infrastructure. Administrators can either modify the date and time zone
settings manually or configure NTP.
If NTP is enabled, the time zone and IP addresses (or host names, if DNS
is configured) of at least one NTP server must be configured on the
library. Contact your network administrator for NTP server IP address
information.
Caution: Using two NTP servers can cause incorrect time
calculations. You should use either one NTP server, or more
than two, but not exactly two.
Chapter 4: Configuring the Library
Setting the Date, Time, and Time Zone
on page 27.
Navigating
47