Quantum scalar i40 User Manual page 269

Quantum Scalar i40 and Scalar i80 User's Guide
Note: If the library is enabled for encryption, unload tapes from all
drives before upgrading the drive firmware.
Web Client
1 Check the Quantum Web site to see if you are running the current
level of firmware (go to
ServiceandSupport/SoftwareandDocumentationDownloads/SI40/
and click the Firmware tab).
Index.aspx
2 If needed, obtain the firmware download file from Quantum
Support and place it in a known location on your computer.
3 Verify with the release notes or Quantum Support that you are
installing the correct version of tape drive firmware for your library.
For support contact information, see
Help on page xxv.
4 Select Tools > Drive Operations.
The Tools - Drive Operations screen displays.
5 Select Upload/remove tape drive firmware for autoleveling and
click Next.
The Tape Drive Firmware Autolevel screen displays. The screen lists
the vendor, type, interface type, form factor, and firmware revision
number for all tape drives that the library supports, whether or not
they are installed in the library.
6 Click Upload.
The Upload Tape Drive Images screen displays. The screen lists the
vendor, type, form factor, and interface type of all tape drives
installed in the library. You can only upload tape drive images for
the listed tape drives.
7 Click Browse.
8 Locate the tape drive firmware image file and click Open.
9 Click Apply. The Progress Window displays. The Progress Window
contains information on the action, elapsed time, and status of the
requested operation. Do one of the following:
• If Complete appears in the Progress Window, the tape drive
firmware upload completed. Check to see if a diagnostic ticket
Chapter 9: Updating Firmware
Updating and Autoleveling Tape Drive Firmware
http://www.quantum.com/
Getting More Information or
243