Viewing Tape Drive Encryption Settings; Installing Tls Certificates On The Library - Quantum scalar i40 User Manual

Viewing Tape Drive Encryption Settings

Installing TLS Certificates on the Library

Quantum Scalar i40 and Scalar i80 User's Guide
You can view the encryption settings in the following ways:
• System Information Report — To view encryption information on
all key servers, partitions, and tape drives, select Reports > System
Information from the Web client. For more information, see
Viewing System Information
• Library Configuration Repor
selected tape drive or tape cartridge, select Reports > Library
Configuration from the Web client and click a tape drive or slot.
The encryption status is displayed in a pop-up status window. For
more information, see
page 220.
• Partition Encryption — From the Web client, select Setup >
Encryption > Partition Configuration to view and change the
encryption settings of partitions. See
Library Managed Encryption
If you are running SKM or a KMIP key manager, Transport Layer Security
(TLS) communication certificates with valid dates must be installed on
the library in order for the library to communicate securely with
attached EKM servers.
At any time, you may install a new set of TLS certificates to overwrite the
existing set. The new TLS certificates must all be valid or the overwrite
will not occur and the existing certificates will remain in place.
Take one the following actions, according to which encryption system
you are using.
Chapter 7: Encryption Key Management
Viewing Tape Drive Encryption Settings
on page 216.
— To view the encryption status of a
t
Viewing the Library Configuration Report
Step 7: Configure Partitions for
on page 183 for more details.
on
189