Chapter 5: Advanced Reporting
Working with Control Path Failover (CPF)
Configuring CPF
Figure 15 Setup - Drive
Settings Screen
Quantum Scalar i40 and Scalar i80 User's Guide
• The control path and failover tape drives must be HP LTO-5 or LTO-6
drives connected to an NPIV-enabled switch on the same fabric.
When control path failover is configured for a partition, the partition
uses a virtual port as the control path communication port. The World
Wide Port Name (WWPN) for this virtual port is listed in the library's
System Information Report in the Library Partitions section under
Control Path (see
Viewing System Information
You can configure control path failover from the Web client only.
Web Client
1 Setup the drive topology.
Set the topology for the control path and control path failover tape
drives to Point to Point. For more information, refer to
Tape Drive Parameters
a Select Setup > Drive Settings.
The Setup - Drive Settings screen displays.
on page 216).
on page 64.
Quantum Scalar i40 and Scalar i80 User's Guide
Configuring
Need help?
Do you have a question about the scalar i40 and is the answer not in the manual?