Figure 32 Configuring Partition Encryption - Quantum scalar i40 User Manual

Chapter 7: Encryption Key Management
Configuring Scalar Key Manager (SKM) on the Library
Figure 32 Configuring
Partition Encryption
184
Configure the partition(s) as follows:
1 From the Web client, select Setup > Encryption > Partition
Configuration.
A list of all your partitions displays, along with the Encryption
Method for each partition (see
Note: The default Encryption Method for a partition containing
encryption-capable tape drives is Application Managed
Encryption (LME disabled). To enable encryption on a
partition, you must select the LME check box to enable
Library Managed Encryption. This is explained in the
following steps.
2 If you want to change the encryption method for a partition, make
sure that no tape drives in that partition have cartridges loaded in
them. If tape drives have cartridges loaded, you cannot change the
encryption method.
3 Select the encryption method for each partition. To enable Library
Managed Encryption for a partition, ensure the LME check box is
selected. See Table 7
encryption methods. The encryption method applies to all
encryption-capable tape drives and media in that partition.
Note: When you change the encryption method on a partition,
the partition is taken offline. When the change completes,
the partition comes back online automatically.
Figure 32).
on page 185 for a description of the
Quantum Scalar i40 and Scalar i80 User's Guide