Quantum scalar i40 User Manual page 197

Quantum Scalar i40 and Scalar i80 User's Guide
Operator Panel
1 Select Actions > Tape Drive > Manual Cleaning.
2 If more than one tape drive is in the library, use the Up and Down
buttons to select a tape drive to clean, then press Clean.
3 When the operation completes, press OK.
Web Client
1 Select Tools > Drive Operations.
2 Select Clean a tape drive and click Next.
3 If more than one partition exists, select the partition that contains
the tape drive you want to clean, and click Next.
The Clean Drive -
is the name of the partition and
offline) of the partition. This screen contains a list of tape drives
assigned to the partition.
4 If you have no cleaning slots configured, skip this step (you will use
the top I/E station slot as the source for your cleaning cartridge). If
you have at least one cleaning slot configured, you are asked to
Select Cleaning Source. Select which location to take the cleaning
cartridge from:
• Use the top I/E slot — Allows you to use a cleaning cartridge
from the topmost I/E station slot. Make sure to install a cleaning
cartridge in the topmost I/E station slot. If manual cartridge
assignment is enabled, assign the cleaning cartridge to the
System partition.
• Use configured cleaning tapes — Allows you to use a cleaning
cartridge from a configured cleaning slot. If two or more
cleaning slots are configured and have cleaning cartridges in
them, the library chooses which cleaning cartridge to use.
5 Select one or more tape drives to clean.
Note: If not all tape drives appear on the screen, use the Page 1
of x arrows to view the additional tape drives.
Chapter 6: Performing Library Operations
Partition (Mode)
screen displays, where
Mode
Cleaning Tape Drives
Partition
is the current mode (online/
171