Figure 31 Configuring Encryption Settings And Key Server; Addresses - Quantum scalar i40 User Manual

Figure 31 Configuring
Encryption Settings and Key
Server Addresses
Quantum Scalar i40 and Scalar i80 User's Guide
Note: You cannot edit the encryption system configuration settings
when any partition is enabled for Library Managed Encryption.
If this happens, go to Setup > Encryption > Partition
Configuration, change all EKM partition settings from LME
enabled to LME disabled. Then make your changes to the
system configuration settings. Finally, go back and change all
the EKM partition settings to LME enabled.
1 From the Web client, select Setup > Encryption > System
Configuration (see
2 Key Server Type: Select which encryption solution you plan to use:
SKM or KMIP Key Manager.
3 Automatic EKM Path Diagnostics: Enable or disable this feature
and set the test interval as desired. Quantum recommends
accepting the default value. For more information, see
Automatic EKM Path Diagnostics
When enabled, this feature performs a check, at specified intervals,
to make sure both key servers are connected to the library and
Chapter 7: Encryption Key Management
Configuring Scalar Key Manager (SKM) on the Library
Figure 31).
on page 188).
Enabling
181