Setting The Time Zone - Quantum scalar i40 User Manual

Chapter 4: Configuring the Library
Setting the Date, Time, and Time Zone

Setting the Time Zone

48
Details on NTP settings include:
• At least one NTP server must be configured and available.
• NTP is enabled on the Date & Time screen. When NTP is enabled,
you cannot manually configure date and time. For more information
on setting date and time manually, see
Manually on page 47.
• You can enter an IP address (or host name, if DNS is configured) for
the NTP servers.
• NTP server IP addresses must be entered in the proper format. See
Configuring Network Settings
IPv4 and IPv6 addresses.
• After you apply NTP settings, system clock synchronization may take
several minutes.
• Enter one or more valid NTP server IP addresses (or host names, if
DNS is configured) in the NTP servers text boxes. Using two NTP
servers can cause incorrect time calculations. You should use either
one NTP server, or three, but not exactly two.
You can only enable and configure NTP on the Web client.
Web Client
1 Select Setup > Date & Time.
2 Refer to the library Web client online help for detailed instructions.
To view the help, click the Help icon in the upper right corner of the
screen.
To select your time zone from a list, disable Use Custom Time Zone
setting and select your time zone from the list.
If your time zone does not appear on the list, or if you want more
control over your time settings, enable Use Custom Time Zone and set
a Universal Coordinated Time (UTC) offset.
You can only set the time zone via the Web client.
Setting the Date and Time
on page 38 for the proper format of
Quantum Scalar i40 and Scalar i80 User's Guide