Shutting Down, Restarting, Turning Off, And Removing Power - Quantum scalar i40 User Manual

Shutting Down, Restarting, Turning Off, and
Removing Power
Quantum Scalar i40 and Scalar i80 User's Guide

Shutting Down, Restarting, Turning Off, and Removing Power

Web Client
1 Click the Logout button in the upper right corner of the screen,
or select Operations > Log Out.
2 Click OK to confirm.
It is important to shut down the library properly before turning off the
library or completely removing library power.
Caution: You should always perform a shutdown before turning off
the library or completely removing power. Otherwise, the
following could occur:
– The library may not complete closing all data and log 
files.
– If you turn off power or unplug the power cord while 
writing to tape, the data on the tape could become 
corrupted.
– If you unplug the power cord, the robot may
become frozen in the middle of an operation and unable
to move once library power is restored, possibly
requiring a service call.
The steps for shutting down, turning off, and completely removing
library power are:
1 Make sure the connected host applications are not sending
commands to the library and that all library operations have
stopped.
2 Shut down the library using the operator panel or Web client (see
Shutting Down the Library
Chapter 6: Performing Library Operations
on page 140).
139