Solenoid - Club Car Precedent 2004 Maintenance And Service

12
ELECTRICAL COMPONENTS
Speed Controller Installation, Continued:
4. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector
Spray (CCI P/N 1014305) to minimize corrosion.
5. Place the Tow/Run switch in the RUN position.
6. Inspect the vehicle for proper operation.
∆
WARNING
• Make sure that the vehicle operates in the forward direction when the Forward/Reverse switch
is in the FORWARD position.
• Make sure that the vehicle operates in the reverse direction when the Forward/Reverse switch
is in the REVERSE position. The reverse buzzer will sound as a warning when the Forward/
Reverse switch is in REVERSE.
• Make sure that the vehicle does not operate when the Forward/Reverse switch is in the
NEUTRAL position.
CONTROLLER

SOLENOID

See General Warnings, Section 1, Page 1-1.
The solenoid is located on the passenger side of the electrical component mounting plate.
Testing the Solenoid
See Section 11, Test Procedure 3, Page 11-20 and Test Procedure 14, Page 11-39.
Solenoid Removal
1. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warnings, Section 1, Page 1-2.
2. Remove electronics module cover. See Electronics Module Cover Removal on page 12-5.
Page 12-12 2004 Precedent IQ System Golf Car Maintenance and Service Manual
1
1
2
1
SOLENOID
Figure 12-10 Component Mounting Plate
OBC
3
2 3
Solenoid