Handling Of Circuit Tester - Kubota GR1600EU Workshop Manual

GR1600EU, WSM

[5] HANDLING OF CIRCUIT TESTER

• Use sandpaper to remove rust from terminals.
• Repair deformed terminal. Make sure that there is no terminal
being exposed or displaced.
(1) Exposed Terminal
(2) Deformed Terminal
• Make sure that there is no female connector being too open.
(A) Correct
• Make sure that plastic cover is large enough to cover whole
connector.
(1) Cover
• Use tester correctly following manual provided with tester.
• Check for polarity and range.
G-7
GENERAL
(3) Sandpaper
(4) Rust
WSM000001GEG0075US0
(B) Incorrect
WSM000001GEG0076US0
(A) Correct
(B) Incorrect
WSM000001GEG0077US0
WSM000001GEG0078US0
KiSC issued 11, 2013 A